The Magic Sky series of products are devoted to improving the environment of living & working airspace. With the bowl as Sky, fog generated by mist maker as clouds, and the adding of a multi-color light creates a wonderful magical animated scene. You immediately realize the benefit of breathing fresh, moisturize air and adding drops of fragrant oils only enhance the experience.
1. Portable cool mist humidifier and aromatic diffuser...All in one.
2. No chemicals or dry ice required. Just keep enough clean water in the bowl.
3. Low 30-watt power and 24 volt transformer for added safety.
1.Refer to drawing No.1, assembly the iron ring and the iron stands. It is the same assembly to MN2 or MN4 stand.
2.Carefully place the glass bowl on the iron stand.
3.Place the Mist Maker & Underwater light into nip-ring of the waterguard (Underwater light head shall be placed in the side which has a small gap), then insert srand of water guard into nip-ring.
4.Place the water guard which has installed electronic unit in the center of glass bowl, adjust the water proof rubber which is attached to the power flex and pull power cord through the hole side of glass bowl, push the rubber firmly into the hole ensuring a tight fit. (GET WET the rubber and the hole so you can do it easily)
5.Place the lotiform cover on the stsnd of water guard, and the bottom of cover should be plugged into ring of water-guard stand.
6.Fill the bowl with water up to about 3/4" from the top.
7.Carefully plug in the connector from mist maker to the power flex from the transformer. (Rfor to the drawing No.3, ensure the arrow mark is exactly, aim at the same side.)
8.Place the transformer into power source and the connector in a dry place away from the mist.
9.Puly the transformer into power source and unit will start working immediately.¡@
1. Exchange water in the bowl as required maintaining unit in a clean operating condition.
2. Use only a soft, clean cloth to clean the surface of Mist Maker & Underwater light. Take special care not to scratch ceramic disc or water lever sensor switch of Mist Maker.
3. After using about 3000 hours the quantity of spraying fog will decline or the unnit may even stop work. However, replacing the ceramic disc will insure continuted operations. Please refer to replacing disc, drawing No.5.
4. The underwater light has a long life, but will eventually have to be replaced. Please refer to replacing bulb, drawing No.4.
5. Replacement disc, tool and bulbs are available from your local distributor.